• Configure hotspot settings When Mobile Hotspot is enabled, the Mobile hotspot icon will be displayed in the Notification bar. Turn mobile hotspot on/off. 1. Swipe down from the Notification bar, then select the Settings icon. 2. Select Connections, then select Mobile Hotspot and Tethering. 3. Select the Mobile Hotspot switch. I'm using Windows Mobile Hotspot on my laptop to share its Internet connection with other devices. It sets up a DHCP service, using 192.168.137.1 as the gateway address, and leasing out addresses on 192.168.137.xxx network. How can I change these settings? INSERTING THE SIM CARD. 1. Open the back cover. We suggest that you hold the Alcatel LINKZONE 2 in one hand and put the tip of your thumb of the other hand into the slot and pull the cover outwards to open it. 2. Press and push the Nano SIM card to install it in the SIM card slot. To add an Access Point Name to your Moxee hotspot modem, please follow these easy steps: 1. Make sure that your device is connected to your mobile hotspot. The purpose of mobile hotspot is to connect computers to internet via mobile data adapter ON THE HOTSPOT. You might as well set the gateway to the IP address of the hotspot each time. It just doesn't make sense to set it to anything else. If you want such network design - don't bother with hotspot program for phones. Even if changing the IP range to 192.168.1.* would be possible, it wouldn't make a difference, because your router's network and phone hotspot's network are two different networks. Share Improve this answer Ifyourplaceofbusinessdoes not allow Wi-Fi or for any other reason you want to disable Wi-Fi and use the mobile hotspot only in tethered mode, the mobile hotspot gives you that option. Note: Whenever you change Wi-Fi settings, any devices connected to the mobile hotspot are disconnected and might need to be reconnected. Sorted by: 1. Run Win + R, type ncpa.cpl into run.. dialog. That'll show you all interfaces. Select one that have internet connection, if you want to share it with your mobile. Click right mouse button and select properties, then on tab Sharing select your wireless interface and check Allow other users then apply these settings. OSBE.